Conveyor Belt Installation

Installation of the offset roller method: If two sets of automatic centering roller (flat roller or groove roller) are installed on the conveyor, the deviation of the tape can be automatically corrected. For example, when the tape is deflected and rubbed on one side of the small stop roller, the bracket on the side should be moved forward in the running direction of the tape, and the other side will move backwards relatively, and the tape will move backwards. Move the roller side until it returns to the normal position.


 Installation limit roller method: If the tape is always offset to one side, the limit vertical roller can be installed on the frame on the deviation side, so that the tape can be forcibly reset on the one hand, and the vertical roller can be adjusted on the other hand. Reduce the tension of the offset side tape and move the tape to the other side.


Installation of automatic correcting device method: Install an automatic correcting device on the conveyor to prevent the tape from running off.